Added eyelids to headlights. Noticed when doing indicator bulbs the top of the lens was getting a bit worn. Looks like a mix of sun and dust blasted stripping off the top layer of polycarbonate.   Will add a door foam tape weather seal above headlights to seal to bonnet to stop the air travelling along top of lens in future.

Car all back in one piece. The roof rail clips all worked fine, but they really do need the 2 little tabs to prevent any movement. The tabs were missing from all but 1 clip when I took them off.  I found a couple in among the plant matter under the rails, but seems they get brittle and fall off.

Headliner back in, just need to tape A pillar wires back to the holders   Lost one bolt somewhere along the way. They were all screwed back in but some fell out when driving. Turns out they are all cage nut from datacenter phone sized, so easy to replace.   Painting went well, no spills or runs. Even colour matched well. Did the stone chips and roof gouge all with reasonable success.    Will give it 24 hours to cure then still the roof rails back on.  

Don;'t suppose you'd be able to chuck up some photos at some point?   I have a Pi4 kicking about doing not a lot, lack a lot brain cells, but I wonder if I could wrangle together something for my WRX, with some chatgpt help  

They are nice cars, until you needs parts.