natsu789

Yup had checked the fuse in the engine bay as well

Woke up today to find someone had broke into my car and mangled my loom, after I reattached my ign, acc etc I noticd my indicators wont work. Pressing the hazard switch in, all lights and dash work and send 6-9v to the combo switch, checked all fuses they are all good tried a different combo switch. Is it possible the flasher relay or hazard switch is gone?, V3 loom if that gives any help any insight on this would be much much appreciated.

Thanks for the help I was a little confused as to if the 3rd wire did go to the the shield or not.

This may be stupid but, I have a v3 sti loom in my car and my front O2 sensor plug is gone, loom side not sensor side, i have a fitting i can solder on from another loom but wiring is way off. And have no idea where to start as the loom only shows 2 wires and a shield, have a photo if it helps any. Sorry if this is in the wrong place.

Needs widebody bad. Did someone say wide body?

Hello I have a 20h that I have started converting and I am stuck on the ecu, that is 4pin and the sti v3 one I have is 3 pin. I read that it can still be used after re-pining some wires but i couldnt find out what ones i need to re-pin. Any help would be great

Hi everyone, I had to take my under manifold air intake pipe off my 1994 rs and cant seem to find where one pipe goes now. only way I can say it is it comes off a part that looks like a "F" coming from the block? under the top mount with the bottem hose going to the sideways pipe on the air intake. I am at a total loss of where the top one goes and its stoping me from getting my engine done. Am greatful for any help. sorry for bad english