Jump to content
Please check your junk folder for registration emails ×

Minaj

General Member
  • Posts

    798
  • Joined

  • Last visited

Personal Information

  • Location
    Auckland
  • Occupation
    Builder

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Minaj's Achievements

Motormouth

Motormouth (4/7)

3

Reputation

  1. Bro, my motor is done CDB 2.1 built stroke cams etc etc. Im picking up motor this weekend and hopefully have it dropped in by next week. I'll let you know how it goes.
  2. The Evo 9 has jun cams, you've heard them/
  3. On E85 depending how hard I drive it would fill up within couple of days.
  4. Sorry, I mean I have had no issues running driftmax intercoolers.
  5. I've been running one from driftmax for 3 years to issues on my high powered build when it was running.
  6. Yup that correct, would've heard it on the dyno.
  7. I paid around $250 for my road tune by papu a few years back and I was very satisfied with the results, I also had my car tuned my Garry Capper and did not notice much of a gain this was on the same setup.
  8. I'm already onto it, I'm in the process of completing my statements backed up with evidence and it's not a easy process.
  9. Yup, even if there was a lot of cam timing or avcs advance added on the intake side, wouldn't all the intake valves kiss? The exhaust is not controlled by avcs just a cam gear, but doesn't explain why the other cylinders don't have valves marks on the piston. Do you know whats the maximum decking limit for the block and max machining for the head is ??
  10. Cam Lift: Intake: 11.50mm Exhaust: 10.75mm Intake duration 272 and Exhaust 268. The adjustable cam gears was 5 and 7 degrees. I was told there was 4.5mm PTV clearance.
  11. Yup I have as well as other tuners. I'm only asking to see if anyone on the fourms has experienced it.
  12. The car was already tuned prior on 98 fuel, I later was tuned on E85 at 17 psi of boost.
  13. CP piston off NZ Performance, it was early square dish type. The thing with my motor some of the intake valves have touched but not all, on the other hand I don't have avcs on the exhaust side but 2 exhaust valves have kissed cylinder 4 piston and the others have nothing at all.
  14. I'm after some of your guy's opinion, have you ever had valves kiss the piston because of a tune i know this may be a stupid question but im only after your insights. I know if you run a lot of advance on avcs there is a chance that your valves would kiss the piston, this is mostly on aftermarket cams, but an engine builder would usually check this and tell you how much you can run before the valves kiss.
  • Who's Online   0 Members, 0 Anonymous, 130 Guests (See full list)

    • There are no registered users currently online
×
×
  • Create New...